Refrigerator Ice Maker Line Installation

The first step to ice maker installation or any supply line plumbing is to shut off the main valve to the house and open the lowest tap on the property to empty the pipes.

Refrigerator ice maker line installation. A universal water supply kit is available at extra cost from the dealer. Running a water line to a refrigerator to supply its ice maker and drinking water dispenser has never been easier. Install into the existing supply line. Take caution to not allow water to seep into your.

In this video i ll show you step by step how to install a water line to your refrigerator for an ice maker or simply for a drinking water supply. If the refrigerator is installed in area with low water pressure below 20psi a booster pump should be installed to compensate for the low pressure. Connecting a water line to your refrigerator will provide it with the water necessary to make ice and dispense filtered water. You can use the water line leftover from your previous refrigerator or start fresh with a new kit from the hardware store.

Water line must be connected to potable water only. Avoid using the bottom of the pipe as this may draw sediment into the ice maker. Drill a 1 4 inch hole into the cold water line for the valve. Find the line supplying the kitchen and cut out a section of the pipe no longer than 2 inches.

At one time this was typically done with 1 4 inch bendable copper tubing that was snaked from the refrigerator to the nearest source of water and tapped into the water line using a saddle valve or other type of fitting.